# Drag/Drop Floor Plan App issues - printing and aligning

**URL:** <https://forum.kirupa.com/t/drag-drop-floor-plan-app-issues-printing-and-aligning/180689>\
**Category:** flash\
**Created:** [March 2, 2006, 7:16pm UTC](https://forum.kirupa.com/t/drag-drop-floor-plan-app-issues-printing-and-aligning/180689 "2006-03-02T19:16:52Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![bchalker](https://yyz1.discourse-cdn.com/flex011/user_avatar/forum.kirupa.com/bchalker/32/441_2.png) [@bchalker](https://forum.kirupa.com/u/bchalker)\
**Post date:** [March 2, 2006, 7:16pm UTC](https://forum.kirupa.com/t/drag-drop-floor-plan-app-issues-printing-and-aligning/180689/1 "2006-03-02T19:16:52Z")

</div>

**Link to SWF:**  
[Floor Plan App](http://ameliapark.discovertecweb.com/appTest/)

**Purpose:**  
Allows users to select products and place onto their floor plans, which is saved into our DB to be loaded by our filed techs to place further “tech-specific” symbols onto the plan. All of this is covered so far, with no problems.

**Issues:**

1. I need the have a print button that will print the floor plan in it’s entirety - the products placed, the full length, NOT scaled to fit on one page, but printed out on however many are need for the full size print.

2. When a product is selected (to place onto the plan), the “attachedMC” is placed at a specific X/Y coord. I am wanting the attachedMC to be placed on the same X/Y coord (upper left of the plan) in relation to the floor plan coordinates. In other words, if the plan is scrolled to the very bottom, and the user selects a product, currently I have the plan scrolling back to the top, and the item placed in the upper left of the plan. I want the product to appear in the upper left of the plan, no matter where the actual plan coords are. Make sense?

**THAT SAID:**  
I’m using Flash 8 for this, hoping to utilize some of the Bitmap manipulation and even file upload (for plans), and even though this app is AS heavy, it’s been a real learning trila for me. I am NOT an expert, and much of the code is probably not as clean as many “gurus” would like ;).

I can send the .FLA (and Prototype .MXP used - Laco) through email. It’s an internal project, so I don’t want to upload it.

---

<div class="post-metadata">

**Author:** ![bradleykal](https://yyz1.discourse-cdn.com/flex011/user_avatar/forum.kirupa.com/bradleykal/32/1447_2.png) [@bradleykal](https://forum.kirupa.com/u/bradleykal)\
**Post date:** [March 20, 2006, 11:22pm UTC](https://forum.kirupa.com/t/drag-drop-floor-plan-app-issues-printing-and-aligning/180689/2 "2006-03-20T23:22:47Z")

</div>

> [@bchalker](#):
>
> Anyone…again?

Hey there, dealing with something similar myself.

Not too familiar with the printing issue; actually seems a bit counter intuitive not to have the florplan scale to a single sheet.

Your welcome to email me the FLA and I can look at that alignment issue for ya.

BTW, Nice looking layout!