Probably a very basic question

[noobie]

I would like to learn more about the symbols circled in red. I figure they might be for alignment or anchoring but I do not know what they are called.:puzzle:

[hybrid101]

i think those are the anchor points:)

[TheCanadian]

The little cross thing is the registration point - it is the centre of the movie clip for all transformations (alignment, rotation, scaling, etc.) at run-time.

The little circle thing is the transformation point which is used for all transformations in the IDE.

Hope this helps :azn:

[suranija]

@TheCanadian

The little cross thing is the registration point - it is the centre of the movie clip for all transformations (alignment, rotation, scaling, etc.) at run-time.

The little circle thing is the transformation point which is used for all transformations in the IDE.

Hope this helps :azn:

That was a very nice explanation canadian…

Great … :thumb2:

[noobie]

@TheCanadian

The little cross thing is the registration point - it is the centre of the movie clip for all transformations (alignment, rotation, scaling, etc.) at run-time.

The little circle thing is the transformation point which is used for all transformations in the IDE.

Hope this helps :azn:

Thank you! Am able to read up more on them now I know what they are called. =)